Importing the starting point measurement
Every measurement may have different results following the Learning Phase, depending on the flows covered in the original application. Since this is a step-by-step tutorial, it is recommended to start by importing the measurement used for the analysis steps in this tutorial.
Go to the vFunction Server Web UI
Switch to the Analysis page, if prompted then stop the learning
Click MEASUREMENTS (bottom of the pane), select IMPORT MEASUREMENT and then CHOOSE FILE in the popup dialog
In the Open file dialog, select C:\vFunctionLab\measurements\Analysis-Tutorial-Start.zip and click Open
Click IMPORT
The initial measurement should load after a few seconds.
Click on the bell shaped icon at the top of the page to see the notifications - you should have a notification that the learning results include beans and database tables.
Click Configure Parameters under ACTIONS in the left pane, and check the checkmark Enable Auto Refactoring (turned on) and close the dialog. This will activate the auto refactoring feature of vFunction - in essence it removes references to classes identified as dead-code based on the analysis as well as unused parts of classes in the context of a domain.